![]() EXTRUDE wouldn't work because the shape and the line are not perpendicular to each other: This is a case where SWEEP works, but EXTRUDE wouldn't. Create a path on the same plane as the closed polyline shape and sweep your newly formed closed shape along the path.Now when you move your cursor over the shape the entire shape should be highlighted:.1 and press to set the fuzz distance (All points within. Type Y and press to convert your lines to polylines. You could use REGION, but there is also another way. In order to use this shape as a profile, you need to make it a closed shape rather than a series of lines.Call the line command and enter coordinates or click on the drawing to create a closed shape made up of at least 6 line segments.Make layer 0 active and turn off the Paths and Profiles layer.Select the paths and profiles and put them on the Paths and Profiles layer.Create a new layer and name it Paths and Profiles.Make layer 0 active and turn off the Sweeps layer.Select the solids and put them on the Sweeps layer.Type SUBTRACT and click on the larger tube.Use the MOVE command to align the two tubes (Make the displacement the center of one of the circular faces and make the second point the center of the other circular face).Repeat the process for the larger circle:.Click on the smaller circle and press.Turn off Dynamic Input if it is enabled.Use ARC or SPLINE to create the path for the extrusion.Draw another circle with a diameter of 4 anywhere in your drawing.Draw a circle with a diameter of 6 anywhere in your drawing.Create a new drawing that is set up for 3D space.
0 Comments
Leave a Reply. |